STIGQter STIGQter: STIG Summary: Arista MLS DCS-7000 Series NDM Security Technical Implementation Guide Version: 1 Release: 3 Benchmark Date: 25 Oct 2019:

The Arista Multilayer Switch must generate audit records when successful/unsuccessful attempts to access privileges occur.

DISA Rule

SV-75303r1_rule

Vulnerability Number

V-60847

Group Title

SRG-APP-000091-NDM-000223

Rule Version

AMLS-NM-000180

Severity

CAT III

CCI(s)

Weight

10

Fix Recommendation

Enable logging on the switch with sufficient detail to fulfill the specifications set forth in the VulDiscussion.

To configure logging to a remote syslog server at the informational level, enter:

switch#config
switch(config)#logging host [ip address]
switch(config)#logging trap informational

Then configure the following AAA:

aaa accounting commands all default start-stop logging [group radius]

Check Contents

Review the switch configuration and verify that logging is enabled.

If logging is not enabled or is not enabled with sufficient detail to fulfill the specifications set forth in the VulDiscussion, this is a finding.

To determine if logging is enabled, enter:

switch#show logging

The output must show logging as enabled, with a logging level of informational or debugging.

In order to ensure all user commands are captured, the following statement must be in the running config:

aaa accounting commands all default start-stop logging [group radius]

Vulnerability Number

V-60847

Documentable

False

Rule Version

AMLS-NM-000180

Severity Override Guidance

Review the switch configuration and verify that logging is enabled.

If logging is not enabled or is not enabled with sufficient detail to fulfill the specifications set forth in the VulDiscussion, this is a finding.

To determine if logging is enabled, enter:

switch#show logging

The output must show logging as enabled, with a logging level of informational or debugging.

In order to ensure all user commands are captured, the following statement must be in the running config:

aaa accounting commands all default start-stop logging [group radius]

Check Content Reference

M

Target Key

2825

Comments