STIGQter: STIG Summary: Ivanti Sentry 9.x ALG Security Technical Implementation Guide Version: 3 Release: 1 Benchmark Date: 24 Oct 2024:

The Sentry providing encryption intermediary services must use NIST FIPS-validated cryptography to implement encryption services.

DISA Rule

SV-251038r1028207_rule

Vulnerability Number

V-251038

Group Title

SRG-NET-000510-ALG-000111

Rule Version

MOIS-AL-001360

Severity

CAT II

CCI(s)

• CCI-002450 - Implement organization-defined types of cryptography for each specified cryptography use.

Weight

10

Fix Recommendation

Configure the Sentry Server to use a FIPS 140-2-validated cryptographic module.

On the Sentry console, do the following:
1. SSH to Sentry Server from any SSH client.
2. Enter the administrator credentials set when Sentry was installed.
3. Enter "enable".
4. When prompted, enter the "enable secret" set when Sentry was installed.
5. Enter "configure terminal".
6. Enter the following command to enable FIPS: FIPS
7. Enter the following command to proceed with the necessary reload: do reload
8. Enter "Yes" at saved configuration modified prompt.
9. Enter "Yes" at proceed do reload.

Check Contents

Verify the Sentry uses encryption services that implement NIST FIPS-validated cryptography to protect the confidentiality of remote access sessions.

On the Sentry CLI console, do the following:
1. SSH to Sentry Server from any SSH client.
2. Enter the administrator credentials set when Sentry was installed.
3. Enter "enable".
4. When prompted, enter the "enable secret" set when Sentry was installed.
5. Enter "show FIPS".
6. Verify "FIPS 140 mode is enabled" is displayed.

If the Sentry Server does not report that FIPS mode is "enabled", this is a finding.

Vulnerability Number

V-251038

Documentable

False

Rule Version

MOIS-AL-001360

Severity Override Guidance

Verify the Sentry uses encryption services that implement NIST FIPS-validated cryptography to protect the confidentiality of remote access sessions.

On the Sentry CLI console, do the following:
1. SSH to Sentry Server from any SSH client.
2. Enter the administrator credentials set when Sentry was installed.
3. Enter "enable".
4. When prompted, enter the "enable secret" set when Sentry was installed.
5. Enter "show FIPS".
6. Verify "FIPS 140 mode is enabled" is displayed.

If the Sentry Server does not report that FIPS mode is "enabled", this is a finding.

Check Content Reference

M

Target Key

5439