STIGQter: STIG Summary: Ivanti Sentry 9.x NDM Security Technical Implementation Guide Version: 3 Release: 1 Benchmark Date: 24 Oct 2024:

Sentry must use FIPS 140-2 approved algorithms for authentication to a cryptographic module.

DISA Rule

SV-250995r1028232_rule

Vulnerability Number

V-250995

Group Title

SRG-APP-000179-NDM-000265

Rule Version

MOIS-ND-000530

Severity

CAT I

CCI(s)

• CCI-000803 - Implement mechanisms for authentication to a cryptographic module that meet the requirements of applicable laws, Executive Orders, directives, policies, regulations, standards, and guidance for such authentication.

Weight

10

Fix Recommendation

Configure the Sentry Server to use a FIPS 140-2-validated cryptographic module.

On the Sentry console, do the following:
1. SSH to Sentry Server from any SSH client.
2. Enter the administrator credentials set at Sentry installation.
3. Enter "enable".
4. When prompted, enter the "enable secret" set at Sentry installation.
5. Enter "configure terminal".
6. Enter the following command to enable FIPS: FIPS
7. Enter the following command to proceed with the necessary reload: do reload
8. Enter "Yes" at saved configuration modified prompt.
9. Enter "Yes" at proceed do reload.

Check Contents

Verify the Sentry uses encryption services that implement NIST FIPS-validated cryptography to protect the confidentiality of remote access sessions.

On the Sentry CLI console, do the following:
1. SSH to Sentry Server from any SSH client.
2. Enter the administrator credentials set at Sentry installation.
3. Enter "enable".
4. When prompted, enter the "enable secret" set at Sentry installation.
5. Enter "show FIPS".
6. Verify "FIPS 140 mode is enabled" is displayed.

If the Sentry Server does not report that FIPS mode is "enabled", this is a finding.

Vulnerability Number

V-250995

Documentable

False

Rule Version

MOIS-ND-000530

Severity Override Guidance

Verify the Sentry uses encryption services that implement NIST FIPS-validated cryptography to protect the confidentiality of remote access sessions.

On the Sentry CLI console, do the following:
1. SSH to Sentry Server from any SSH client.
2. Enter the administrator credentials set at Sentry installation.
3. Enter "enable".
4. When prompted, enter the "enable secret" set at Sentry installation.
5. Enter "show FIPS".
6. Verify "FIPS 140 mode is enabled" is displayed.

If the Sentry Server does not report that FIPS mode is "enabled", this is a finding.

Check Content Reference

M

Target Key

5438