STIGQter STIGQter: STIG Summary: A10 Networks ADC ALG Security Technical Implementation Guide Version: 1 Release: 1 Benchmark Date: 15 Apr 2016: The A10 Networks ADC must generate an alert to, at a minimum, the ISSO and ISSM when threats identified by authoritative sources (e.g., IAVMs or CTOs) are detected.

DISA Rule

SV-82595r1_rule

Vulnerability Number

V-68105

Group Title

SRG-NET-000392-ALG-000142

Rule Version

AADC-AG-000114

Severity

CAT II

CCI(s)

Weight

10

Fix Recommendation

These are two of the three possible methods of notification that can be configured.

The following command enables SNMP traps:

snmp-server enable traps

Note: This will enable sending all traps.

The following command configures the SNMPv3 trap receiver (target):

snmp-server host trap-receiver version v3

Up to 16 trap receivers can be configured.

For security, SNMP and SNMP trap are disabled on all data interfaces. Use the enable-management command to enable SNMP on the management interface.

The following command configures log email settings:
logging email buffer number [num] time [minutes]
By default, emailing of log messages is disabled. If this is enabled, the buffer options have the following default values: number – 50, time – 10.

The following command configures an email filter:
logging email filter filter-num conditions operators [trigger]
Since there are alerts that require immediate action, use the "trigger" option. This immediately sends the messages rather than buffering them.

The following command specifies the email address to which to email the log messages:
logging email-address [address]
More than one email address can be set.

Check Contents

Ask the device administrator which method is used to send messages when threats are detected.

Review the device configuration.

If there is no method and target configured, this is a finding.

Vulnerability Number

V-68105

Documentable

False

Rule Version

AADC-AG-000114

Severity Override Guidance

Ask the device administrator which method is used to send messages when threats are detected.

Review the device configuration.

If there is no method and target configured, this is a finding.

Check Content Reference

M

Target Key

2913

Comments